≡ Menu

Fast Gun Cannon Part Kits

Single cannon pack. Sold in quantities of four or ten.

Strike Models is doing its final packing for long-term storage. Here is your chance to pick up cannon parts for future builds. All sales are subject to prior sale, but I have parts for hundreds of packs.

Each cannon pack includes a machined tee, magazine end, spring, interrupter, stainless steel barrel (with bushing), a 5 or 12 volt solenoid (your choice), quick connect fittings for the solenoid, and a custom elbow allowing the solenoid to be directly connected to the bottom of the tee (parts are included to run the cannon with or without this elbow; will need 4-40 set screw to adjust interrupter height and gasket to to bottom out thread if used).

This kit does not include a Foster breach elbow (a flaw was found after ordering the batch of them), nor does it include any tubing, the magazine cap, or compression cap to set up the interrupter height. The barrel will be raw cut and so will need to be sanded clean and have the safety pin hole drilled by you. While I still have them in stock, each pack will include a single barbed fitting for the end of the magazine. See the picture above showing what is in each.

 

5V Canon parts pack (4 pack): $120 Add to cart
5V Canon parts pack (10 pack): $260 Add to cart

12V Canon parts pack (4 pack): $120 Add to cart
12V Canon parts pack (10 pack): $260 Add to cart

5V Solenoid: $24 Add to cart
5V Solenoid 10 pack: $200 Add to cart
2.5mm Orifice Solenoid Valve for 4 to 8 Volt operation. Comes with 1/4″ input and 1/8″ output quick connects.

12V Solenoid: $24 Add to cart
12V Solenoid 10 pack: $200 Add to cart
2.5mm Orifice Solenoid Valve for 9 to14 Volt operation. Comes with 1/4″ input and 1/8″ output quick connects.

Solenoid Spare Actuator: $5 Add to cart
Viton seal actuator for the Strike Models solenoids

Stainless Steel Barrel: $5 Add to cart
5 inch stainless steel barrel and brass bushing. Barrel will need to be sanded and have hole drilled for safety pin.

Cannon Spring: $3 Add to cart
Cannon Springs (10 pack): $20 Add to cart
Stainless fast gun cannon springs; standard across all Strike Models and SwampWorks cannons.

Cannon Interrupter Pin: $3 Add to cart
Cannon Interrupter Pin (10 pack): $20 Add to cart
Injection molded interrupter pin for Strike Models custom tees. These pins are too short for most tees. Stem length is 0.400″.

Cannon Interrupter Pin 0.525″: $3 Add to cart
Cannon Interrupter Pin 0.525″ (10 pack): $20 Add to cart
Injection molded interrupter pin for tees with small cut for pin head. Standard size for most SwampWorks and Strike Models tees until the most recent batch.

Cannon Interrupter Pin 0.675″: $3 Add to cart
Cannon Interrupter Pin 0.675″ (10 pack): $20 Add to cart
Injection molded interrupter pin for tees without any cut for pin head. These tend to have a little flash, but trivial to clean off. This is not the correct pin for any Strike Models or SwampWorks cannon, but potentially useful for homemade cannons. You can cut them to length as needed.

Interrupter Pin Sizes.

Three cannons with integrated solenoids in the aft end of a North Carolina

Integrated Solenoid cannon on North Carolina side mount.

Integrated Solenoid Cannon on North Carolina.